Sparky

Dell-EMC Unity and Cisco Nexus connectivity

Recommended Posts

Good morning everyone.

I've just taken delivery of some new Dell-EMC Unity 450F arrays (in part due to the comprehensive review here: https://www.storagereview.com/dell_emc_unity_450f_allflash_storage_review), and am looking to configure networking to a pair of Cisco Nexus 9000 series switches, configured with a vPC peer link.

So far, this is what I've got configured:

  • Unity port A0 - Cisco Nexux 1 port 1, VLAN 100
  • Unity port A1 - Cisco Nexus 2 port 1, VLAN 110
  • Unity port B0 - CIsco Nexus 1 port 2, VLAN 100
  • Unity port B1 - Cisco Nexus 2 port 2, VLAN 110

This is as per the attached diagram. All ports are via 10GbE optical SPF+ (we have SPF+ modules in both the onboard CNA ports and a 4 port I/O module), and each port on the Nexus is configured as a iSCSI interface (4 in total). At least for the time being, all connectivity will be via block/iSCSI.

A few follow-up questions on the above:

  1. Is this actually a valid configuration?
  2. Should I be looking to have the separate VLANs across each switch (i.e., A0 to Nexux 1 via VLAN100, and B0 to Nexus 2 via VLAN100)?
  3. Is it accurate that LACP and FSN cannot be configured for block iSCSI access?
  4. Would it be wise to utilize both the onboard CNA ports and I/O module ports for each controller (say, one on each) to provide extra redundancy?

Thanks in advance for any assistance with this.

 

 

Capture99.PNG

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now