pcarey 0 Report post Posted December 4, 2013 I recently upgraded my two 500GB SATA RAID1 HDD’s to two new identical Seagate SATA 1TB drives on my Intel ICH10R RAID motherboard controller and, after copying the old boot drive to the new boot drive, I set up RAID1 in the same configuration as before with Intel Rapid Storage Technology v.10.6.0.1002 and let the controller rebuild the new 1TB mirror drive. However, in physically installing the new drives, I mistakenly connected the primary boot drive to SATA Port 1 and the mirror drive to SATA Port 0. For various reasons, I would like my primary boot drive on SATA Port 0 and the mirror drive on SATA Port 1. Can I just switch the SATA ports that these drives are connected to? How will the controller handle it? Is there any good reason not to do it? Share this post Link to post Share on other sites
dietrc70 6 Report post Posted December 9, 2013 I'm pretty sure I've done this with no problems. Share this post Link to post Share on other sites