Dave A

RAID 50 Configuration Advice

2 posts in this topic

Hi there,

I'm a RAID novice so please bear with me...

I have some very specific constraints.

I have an HP DL360 with 10 1.2 TB 10K disks - the max this box will take. I need RAID and I need around 9TB useable. The workload is predominantly large sequential write and random read. I'd like to reserve a drive for OS and swap. I'm looking to get the best balance of read/write performance.

My thought therefore is to use RAID 5+0. I am thinking of 3 RAID 5 sets of 3 disks each, then stripped. Is there a better configuration given the above constraints?

This box comes with these controllers as standard:

HP Smart Array P420i/1GB with FBWC (RAID 0/1/1+0/5/5+0)

HP Smart Array P420i/2GB with FBWC (RAID 0/1/1+0/5/5+0)

HP Smart Array P420i/1GB FBWC (RAID 0/1/1+0/5/5+0)

I'm assuming the 2Gb version is best to help mitigate the write penalty. Any comments on controllers would be welcome.

Thanks!

Dave

Share this post


Link to post
Share on other sites

For the best performance and best data retention I would recommend Raid 50. In raid 50 just as in raid 5 anything over 4 to 5 disks in an array your percentages of data loss rises. So in order to stay in a fail safe area, never build a raid 5 array larger than 4 or 5 disks. So under raid 50, you will want to create two 4 or 5 disk arrays under raid 5 and both will be covered under raid 0 in raid 50. This will give you the highest redundancy and leave you a drive for a hot spare. I hope I explained this correctly, if not I'm sure others will chime in..

Hi there,

I'm a RAID novice so please bear with me...

I have some very specific constraints.

I have an HP DL360 with 10 1.2 TB 10K disks - the max this box will take. I need RAID and I need around 9TB useable. The workload is predominantly large sequential write and random read. I'd like to reserve a drive for OS and swap. I'm looking to get the best balance of read/write performance.

My thought therefore is to use RAID 5+0. I am thinking of 3 RAID 5 sets of 3 disks each, then stripped. Is there a better configuration given the above constraints?

This box comes with these controllers as standard:

HP Smart Array P420i/1GB with FBWC (RAID 0/1/1+0/5/5+0)

HP Smart Array P420i/2GB with FBWC (RAID 0/1/1+0/5/5+0)

HP Smart Array P420i/1GB FBWC (RAID 0/1/1+0/5/5+0)

I'm assuming the 2Gb version is best to help mitigate the write penalty. Any comments on controllers would be welcome.

Thanks!

Dave

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now