Sign in to follow this  
jmw

1 SSD to 2 SSDs (in RAID 0)

Recommended Posts

Has anyone been successful in taking an already installed Windows 7 OS on an AHCI SSD drive, and then imaged that drive, set up a RAID 0 SSD configuration, and then restored that image to the RAID 0 array...successfully? I was able to create the RAID 0 volume and restore my Windows OS (using TI 2010)...but it would blue screen at boot time. I even tried regedit-ing iaStorV Start DWORD from 3 to 0 before imaging the old drive...but still got the BSOD. Is this ALWAYS a start over situation? Or can it be done without starting over?

Share this post


Link to post
Share on other sites

I have run into that problem on a few systems. Some work, other don't. What hardware are you using for this build?

2 64GB Adata SSD drives (S596 & S599) configured for RAID 0 on a GA-EX58-UD4P MB (BIOS F14n) running Windows 7 Ultimate 64 bit.

Share this post


Link to post
Share on other sites

It sounds like you are using a different drive controller for the RAID array than you started on, in which case you will need to reinstall

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this