Pulsar 2003

Member
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Pulsar 2003

  • Rank
    Member
  1. Pulsar 2003

    Installing W7

    Hello, I've been trying to re-install W7 on a larger SSD driver (Intel SSDSC2W120A3). The installation goes fine until the computer resarted for the third time (I think so). I can see the pale blue screen with the two green process bars appear; the second bar is about 2/3 done. The screen goes black. Nothing appens beyond this point. It's then that I realized that I have have the same problem many years ago and I had to send my computer to a repair shop. I had postpone the re-intallation because of this problem but had forgot about what the issue had been. I still can run my computer because the former installation is on another SSD (SSDSA2CW080G3). It is completely full so I can no longer remove or install software even on other disks. There are no document what so ever on this SSDs, they are on a HDD. And to be safe I unplug them before power up and making a new installation (had made a mistake once a erased a whole disk of documents..). I can access the drive where the new installation is and see all the files. Can the problem come from the DVD? Any thing I can do myself? Thanks
  2. Pulsar 2003

    Intel 520 120G

    Almost six months later... I gave it a try. I once have had that problem but I had forgotten all about it. It all worked out fine. Installing W7 is another story so I will search the forum. Thanks FastMHz
  3. Pulsar 2003

    Intel 520 120G

    Hello everyone I’m here because I have searched the internet to find a solution to the installation of a SSD. Here are some details about my hardware: Motherboard is an ASUS P9X79 Deluxe and SSD is SSDSC2CW120A3. I already have another Intel SSD on that computer: SSDSA2CW080G3. Here is the situation: My 80G SSD is full. What I want to do: Keep my W7 on the 80G and remove all the programme files (in other word uninstall all the software from that drive), crate a programme file on 120G SSD and reinstall all my software on it. Finally I have a WD 320G HDD with all my documents on it. I’m familiar with electronics so the installation of the hardware is not an issue for me. So I made the installation and got my computer running. This motherboard has 8 SATA ports. 4 for 6.0Gb/s and 4 for 3.0Gb/s. The 4 for 3.0Gb/s are used already. And because of the capacity of the 120G it is obviously to use the 6.0Gb/s ports. If you want to refer the User Guide you will find the information on pages 2-26 and 2-28. Currently it’s connected to SATA6G_E1. I also tried the SATAG_1 (but I didn’t check in the device manager to see how it showed). Now I to format this drive, to my surprise the new SSD drive doesn’t show in my “Computer”. To validate I went to “System” “Device Manager” ”Disk Drives”, there is shows. The 80G is shown as: SSDSA2CW080G3 ATA Device while the 120G shows as SS DSC2CW120A3 SICI Disk Device. And notice that the identification is split SS D. I wrote is as it shows. Can anyone tell me what to do to fix this? I want to point out that when I installed the 80G I was unable to do it, I had to send my computer to a technician. Thank you.