wudstock

Member
  • Content count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

About wudstock

  • Rank
    Member
  1. Hello all, I hope I can ask a question about my 3Ware 9550SXU-12 SATA controller. Let me just say after purchasing it I quickly realized I should have looked for a newer card. Here's my setup: Dell Poweredge 2800, 9550SXU-12 SATA controller with 9 drives connected (3 are 3tb drives, the rest are 1tb). Since there is data already on the drives I had to set them up as JBOD because 'Single Disk' mode will wipe the drives. (I know JBOD sucks and I will be updating my drives over time and turning them into 'Single Disks' instead) I knew with the 3tb drives I would have to turn on Auto-Carve to use them, but that doesn't seem to be working as I still see them as 746gb. The main issue is with the 3 (3tb) drives I have. One of the three is recognized in Windows just fine. The other two are seen as RAW and not accessible at all. (That's why I think auto-carve isn't working because I should have 4 drives instead of 2) The drives are as follows: Working: Toshiba HDWD130 (7200 RPM, SATA III) Not working: WDC WD30EZRX-00DC0B0 and WD30EZRX-00SPEB0 (Both 5400 RPM, SATA III) My question is would RPMs on the drives be an issue that might cause something like this? Other than the manufacturer, that's the only difference between them. Any help on this would be appreciated immensely Russ K
  2. Sorry this post was added by mistake and I don't know how to delete it.